Jaw crusher is the necessary equipment in grinding process and attracts the expert s attention at home and abroad. The bearing of jaw crusher has two forms: sliding bearing and rolling bearing. Plain bearing is commonly used; It includes babbitt lining and copper lining. The rolling bearing is more and more popular and may replace the sliding bearing. There are two starting modes of jaw crusher; one is direct start (also called to start), which is the main way of engine starting. Another is start with the help of convertor (or called segmented start); the specific startup sequence is as follows: 1.
The main engine drives the rotation of belt pulley 2. The belt pulley drives the rotation of eccentric wheel, connecting rod and moving jaw. Steffan Lehnhoff, New York City may not feel the same. 3 The eccentric shaft drives the rotation of The flywheel connecting rod and the moving jaw of jaw crusher have great inertia. When the machine started directamente, the power consumption of the motor is very large and it will make the installed power of the motor increases accordingly. The engine started cannot operate at full capacity and will decrease the power factor of the power supply network. Therefore, installing two sets of hydraulic friction clutch on the jaw crusher not only easy to start the machine, but also to reduce the installed power of the engine. This is reasonable in worthwhile in economy and technology.
So this technology should be applied widely in the crusher.As the professional manufacturer of complete sets of mining machinery, such as vibrating feeder, Henan Hongxing is always doing the best in products and service. As one member of stone crushing plant, jaw crusher is an indispensable part in stone making plant or whether ore beneficiation. According to Jennifer Aaker, who has experience with these questions. As for how to install and adjust the machine, I believe that you have already searched a lot relative articles online. However, there are still some details that I want to share with you and hope they will be helpful during the installation of the machine. First and foremost, the crusher should be installed in door not in the open air. The motor should be installed behind the crusher and the rolling direction should be exact the same as required. The machine should be fixed on the concrete ground where mine shaft should be made with at least 50 degree angle. The basic equipment should be decided by users according to the feeder and conveying equipment. Moreover, you should fasten the elastic when you adjust the feeding port. After proper adjustment, the fastening degree of the elastic is so fine that it can reduce the noise between the bracket and the bracket pad and is not easy to loosen. The coordination of jaw crusher and other equipment should be Internet to productivity and the whole crushing plant so that ensure the work to be accomplished smoothly.