The Foundation

posted in: News

Is it possible to calculate the sediment logs? Depending on the initial moisture content of logs, it varies Within 1/20-1/30 height of the wall So over boxes of window and door openings leave a gap filled with oakum. What is the technology of laying log walls? Baulk at first do not add up to the foundation, and in the side to give him , wait for 9-12 months. Outer side of the log is determined that where the annual rings are denser. Because there is stronger than wood. To align the crowns of horizontal beams laid butt in different directions. The first (lower) of the framework (it is called a salary) should be thicker than the next centimeter-ditch 5.

The wall will be safer if the first crown to collect oak and larch. Along the entire length of the logs, stacked in for the next salary wreaths, an ax felled a round groove, so that they would like covered with the previous ones. For connection logs vertically chisel every five feet hammering holes for studs (diameter – 4.3 cm). They are not alone under the other, but staggered. Sheep slaughter is not to the bottom of the hole, and leaving 2-3 cm of emptiness. Before we move frame to the foundation should be put around the perimeter of several layers of roofing material and tarred board thickness of 20 or 30 mm. As fixed angles of walls of wooden houses? There are 5 ways: in the butt to poldereva, a thorn in the cup, in a paw.

Only the third way (a spike) rescues from drafts in the corners. But it is the most time-consuming way. Therefore, builders without the effective area of the home. When logging in the "paw" should be very careful when marking and , or cutouts on the ends of rims do not match. When you need to caulk wooden walls? Simultaneously with the erection. At each crown fits dry tow or moss layers. Each layer should be slightly wider than the groove next crown. Insulating layer should be thicker than an inch, and over the windows and doors, taking into account future shrinkage and shrinkage at home, 4-5 cm more a year later, when the timber finally "find their place, the remains of moss and hemp need caulked into the grooves. How to "ennoble" outside the walls of wooden houses? Log house looks good even without paint, but brusovoi house desirable to sheathe, for example, a board-lining or even impose a brick (a half-brick) Although wooden wall not tolerate such a finish as worse than the "breathing". That the wall did not dampen, to take care of ventilation. And no Do not upholstering the wooden walls of roofing material: heat saving a little, but the rotting wood will be thorough. What are disadvantages of wooden walls? In addition, the walls of wood are flammable and are exposed to insect decay, after the construction of wooden walls before they finish must be at least a year until the walls "settle". The magnitude of rainfall could reach 10%, significantly higher than that of stone or Karka governmental walls (1 -3%). Timber during drying may be deformed. walls – a complicated and expensive procedure. Therefore advisable to use wood in the construction of small houses (not more than 2 floors).

This entry was posted on June 23, 2011 at 5:21 pm and is filed under News (Tags: ). You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.

Comments are closed.

  • Archives

  • Tags

  • Texas A&M Alumni